Ways to connect O-ring Chains Remarks to connect common O-ring Chains

one.A connecting website link of an O-ring Chain for common application is pre-coated with grease in the pins. Before connection, confirm the grease about the surfaces of pins, and in case the quantity of grease is small, apply grease with bare hands. (If gloves are made use of, the grease are going to be absorbed through the gloves.)
Example: Once the connecting website link (I) of an O-ring chain for general application is
shipped, O-rings are fitted in the roots of your pins. Should the O-rings come loose due to vibration all through transport, refit the O-rings in to the roots of your pins.
In this case, you should definitely return the grease collected in the roots in the pins to the central surfaces of your pins, much more at portion A than at portions B shown during the above illustration. (Portions A is worn due to sliding with the bushings.)
2.The chain is often most quickly connected within the teeth of the sprocket. Engage the hyperlinks at each ends from the chain with all the sprocket teeth and fit connecting pins. When the sprocket can be moved, the chain can also be linked around the loosened side.
3. Connecting process
1.Verify that O-rings are connected for the roots with the pins.
2.If the level of grease utilized to the connecting pins is little, coat the pins with grease with the central portions.
3.Insert the connecting pins to the bushings from the inner hyperlinks at the two ends.
four.Verify that the grease is applied towards the whole face of the O-ring, and match the O-ring onto the connecting pins.
5.Insert the connecting pins in to the connecting plate and whilst pressing the connecting plate, set up the spring clip. Confirm whether or not the head (the end without a split) on the spring clip is turned within the feeding course in the chain. (See the following illustration.)
6.Be sure you confirm that the spring clip is securely fitted inside the clip grooves with the connecting pins.
This completes jointing in the connecting hyperlink. Note that grease on the surfaces of connecting pins and O-rings is usually removed through installation function. In this instance, re-grease utilizing the grease on the surface of the base chain or even the grease inside the polyethylene bag by which the connecting link was contained.