Material Managing Electrical power UNIT 1
This power unit is built for that fork lift field, consisting of remarkably productive gear pump, DC motor, guide raise and reduced valve, tank, ect. The up and down movement are managed from the lever with the guide release valve, and that is outfitted with an electric switch to activate the motor. The lowing velocity is controlled by the strain compensated movement control valve.
one. The duty of this power unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean the many hydraulic elements concerned prior to set up of the energy unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst, which need to also be clean and no cost of impurities, N46 hydraulic oil is advisable .
four. Oil changing is needed just after the original 100 operation hours, afterwards when just about every 3000 hours.
5. The energy unit proven is intended to be mounted horizontally.
Material Managing Power UNIT two
This energy unit functions electrical power up gravity down circuit. Activate the commence solenoid to start out the motor to lift the machine. The lowing motion is activated through the solenoid valve together with the decreasing speed controlled from the strain compensated movement management valve. Items of this series may be broadly utilized in the sector of logistic units such as fork lift, mini lift table, etc.
one. The duty of this energy unit is S3,i.e.,thirty seconds on and 270 senconds off.
2. Clean each of the hydraulic parts concerned just before mounting the energy unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities, N46 hydraulic oil is advisable .
four. Oil modifying is needed right after the initial a hundred operation hrs,afterwards when just about every 3000 hrs.
5. The electrical power unit need to be mounted horizontally.